Impacts S210E, Руководство по эксплуатации

Страница: 21 / 48

Operating Manual S210E
19
5.2 Filling the Abrasive Hopper
1. After you have checked the blast machine for
safety, make sure that the lever (Dead Man
Switch) (1) is in the lower position and the
magnetic valve (2) is closed.
2. Open the clamps (3) and move the cover (4)
upwards.
3. Put the cover on the transportation handle (5).
4. Fill the right IMPACTOR abrasive in the
hopper until you have reached a level just
below the wire mesh (6).
5. Close the cover and fix it with the clamps (3).
6. Check that the dust container of the dust
collector has been emptied.
All persons near the machine must wear safety glasses with lateral protection, ear
protection as well as safety shoes. The operator is obliged to wear close fitted
protective clothing.
5.3 Start Up
The working and moving direction of the blast machine is in the direction of the arrow (V) shown on
the picture. The blast machine and the dust collector must be started in the following sequence:
1. Switch on the dust collector.
2. After the dust collector is running, start up the
blast machine as described below.
3. Make sure that the emergency switch (1) is in
the upper position and not pushed down.
4. Push the machine by using the handle (2)
slowly in the direction of the arrow (S) forward
(V) and at the same time pull the lever (3)
slowly up as much as you can. This action
starts the wheel motor and at the same time the
magnetic valve opens and abrasive flows into
the blast wheel.
5. Continue to push the machine slowly in
direction of the arrow (V) and carefully watch
the blasted area. If necessary, change the
moving speed to achieve the blasting profile
you require.