Impacts S210E, Руководство по эксплуатации

Страница: 23 / 48

Operating Manual S210E
21
Chapter 6.0 Operation
6.1 Daily operation
6.2 Information about Traveling Speed and Abrasive Feeding
6.3 Turning Off the Machine
6.4 If Failure Occurs
6.5 Restarting after a Fault
6.6 Proceedings Prior and After Longer Stoppage
6.1 Daily Operation
This operating manual has to always be with the machine at the working site!
Only trained personnel can operate and perform work on the machine. Note the
statutory minimum age! Clearly specify the responsibilities of personnel for
operation, setup, service, and maintenance work.
Instructions for daily operation of the blast machine:
• Before starting the operation, check daily whether all machine parts are assembled safely and
correctly.
• Before switching on the machine, check that all safety covers are in the right position and that the
dust collector is connected correctly.
• Use only a dust collector which that has the right suction power and offers an optimal dust
separation.
• Treat all plugs, cables, hoses, and operating devices with special care. Avoid any contact with live
wires.
• Check the surface to be treated for loose parts (Stones, screws, etc.) The surface must be swept
if necessary. Remove all objects from the surface in order to avoid damage to the machine seals
or serious damage to blast wheel and wheel-drive.
• Make sure that no vehicles, such as forklift trucks and other equipment run over the electric cable
and the dust hose.
• When using the dust collector, make sure to comply with the health and safety regulations and the
local waste treatment regulations considering the removed material.
• Perform regular inspections in order to avoid downtimes of your blast machine (see Chapter 7
"Maintenance").
All persons in the proximity of the machine must wear safety glasses with lateral
protection as well as safety shoes. The operator of the machine is obliged to wear
close-fitting protective clothing.