Impacts S210E, Руководство по эксплуатации

Страница: 15 / 48

Operating Manual S210E
13
3.8 Blast Head Sealing
There are seals in the front, in the rear and on the two sides of the blast head. The sealing system on
the sides and in the front are magnetic seals with brush seals on the outside.
The rear seal is a brush only. These sealing
together form the blast head sealing. The blast
head sealing is designed to seal the blasting area
in a way to avoid leakage of abrasive.
The correct height adjustment of the magnetic
seals (6-8mm) is very important for an optimum
performance of the machine. The adjustment can
be carried out by setting screws of back wheel
fixing and adding distance rings to the front wheel
fixing.
1 Side brush seals
2 Side magnets
3 Brush seals front and rear
4 Front magnet
3.9 Suction System
During the operation of the machine and the dust collector the airflow (air suction) has the following
effects:
• Coaling of blast wheel, abrasive and of the blast housing
• Transportation of the abrasive and the dust trough
the system
• Separation of the dust from the abrasive
• Transportation of the dust to the dust collector
The airflow takes the following way through
the machine:
The blast head sealings are responsible for the
regulation of the air on the inside of the machine.
The airflow enters the machine through the rear and
goes through the rebound channel. It transports
abrasive and dust upward.
At the same time, the airflow gives cooling to the
abrasive and the rebound channel.