Impacts S210E, Руководство по эксплуатации

Страница: 20 / 48

S210E Operating Manual
18
Chapter 5.0 Start Up
5.1 Preparing for Start Up
5.2 Filling the Abrasive Hopper
5.2 Start Up
5.1 Preparing for Start Up
Move the blast machine and the dust collector to the working site.
Check the blast wheel, control cage, feed spout, all liners, and the separator for damages and wear.
Worn and damaged parts have to be changed before starting the work.
Before switching on make sure that all existing protective housings are mounted and that a sufficient
dust collector is connected correctly.
All persons in the proximity of the machine must wear safety glasses with lateral
protection as well as safety shoes. The operator is obliged to wear close fitting
protective clothing.
Before start-up, operators and other personnel must be familiar with the safety
regulations given in this manual.
1. Handle all plugs, cables, hoses and operating devices with care. Avoid any contact with live
wires. Work on the electrical system must only be carried out by a qualified electrician.
2. Check the surface to be treated for loose parts (stones, screws, etc.).The surface must be
swept if necessary. Make sure that the machine can travel over all inequalities on the surface.
Small inequalities like welding seams or floor joints are no barriers for the machine.
3. Check the height adjustment of the blast machine (approx. 6-8 mm). See Chapter 7 of the
operating instructions.
4. Check the main electrical cable and the dust hose for damages. Exchange or repair all
damaged parts before starting the machine.
5. Connect the blast machine and the dust collector unit with the dust hose. Use hose clamps at
the connections.
6. Connect the supply cable of the dust collector with the site supply.
7. Connect the supply cable of the blast machine with the site supply. Make sure, that the right
connection (110 V, 60 Hz, 20A) is available.