Impacts S210E, Руководство по эксплуатации

Страница: 16 / 48

S210E Operating Manual
14
The airflow enters the separator, separating fine dust from the abrasive, and transports the dust
through the exit opening to the dust collector. The separator head is completely sealed by a special
sealing.
Make sure that there are no holes (unsealed areas) in the blast housing, the feed
spout and the separator.
Then the airflow goes trough the flexible dust hose and takes dust and fine particles to the dust
collector. All connecting points have to be sealed carefully. The dust hose has to be fixed with special
clamps.
Then the airflow comes into the filter chamber of the dust collector. Here dust and fine particles are
separated and the clean air goes back to the environment.
The Dust collector housing must be sealed carefully. All sealings have to be in good
condition.
If dust comes out of the dust collector, either the dust collector is damaged or it is not correctly sealed.
Please make sure, that only correct material will be used. The use of damaged filter cartridges or
damaged filter bags can badly damage the function of the machine.
Required dust collector:
• Suction power min.: 300 CFM
• Electrical power: 2,000W
• Length of electrical cable: 25 ft. (7.6m)
Dust hose:
• Length: 30 ft. (9m)
• Diameter: 2 in. (51mm)
3.10 Abrasive Media
In order to operate the IMPACTS blast machine S210E you need hardened, round abrasive.
The IMPACTS abrasives IMPACTOR S330 and S390 are standard abrasives, which can be used for
most of the applications. The machine has been specially designed to use these abrasives.
The IMPACTS abrasive IMPACTOR is a very high quality blast media. It has the right rebound power
to use the S210E blast machine very efficiently. The selection of the blast media is very important
consideration for proper treatment to the floor surface.