IHI NIIGATA MG(L)26HLX, Инструкция по эксплуатации

Страница: 89 / 204

This document is property of NIIGATA POWER SYSTEMS CO., LTD. It must be neither reproduced nor communicated nor published without permission.
S E C T I O N
３
- M A I N T E N A N C E
3.1 G E N E R A L
３－１－０１
3.1 GENERAL
3.1.1 Introduction
This manual is intended to the operation and maintenance departments,
containing the instructions necessary for maintaining the engines.
However, the content is shown as standard, practical maintenance varies by
application of engine, fuel oil to used, etc.. Therefore, maintenance
method of each plant should be amended according to the actual results.
Caution :
CAUTION
Be sure to put on safety goggles in carrying out the following items of work being
in danger of injury to eyes.
・
When handling fuel oil, lubricating oil, cooling water and inhibitor,
and anti-freeze solution
・
In course of washing work
・
In course of fuel injection valve injection test
・
When handling battery electrolyte
・
In course of grinding work
・
In course of intake/exhaust valve grinding work
There is a danger of injury to your hands during the work inside the engine room
and enclosure.
Be sure to put on gloves for the protection of your hands except for the case of
special work.
There is a danger of your body being pinched by the doors of enclosure and engine
room that are designed to be readily closed by the difference in atmosphere
between the inside and outside.
Take precautions so that your body will not be pinched.
(1) Carry out the periodic maintenance according to settled schedule.
However, if abnormality is detected when running, carry out
・
trouble-shooting and counter-measure as soon as possible.
(2) Criterion of parts which is repaired or exchanged is identified follows.
LA
＝
Limit beyond which the part dimension may reach LR prior to the next
routine inspection.
LR
＝
Limit beyond which the use of the part is hazardous rework or immediate
・
rejection.
MO
＝
Theoretical dimension on the drawing.
(3) Grasp the number of parts in stock usually. Prepare the necessary parts
before next periodical maintenance.
(4) In order to prepare the emergency, arrange the tools for disassemble and reassemble.