IHI NIIGATA MG(L)26HLX, Инструкция по эксплуатации

Страница: 119 / 204

This document is property of NIIGATA POWER SYSTEMS CO., LTD. It must be neither reproduced nor communicated nor published without permission.
S E C T I O N
３
- M A I N T E N A N C E
3.5 MAINTENANCE AND INSPECTION SCHEDULE
３－５－０９
●
Inspection D
Interval : 5,000 hours
No Maintenance work reference
D -01
D -02
D -03
D -04
D -05
D -06
D -07
D -08
D -09
D -10
D -11
D -12
Cylinder head (MDO operation)
- Check intake and exhaust valve/valve seat, and recondition.
- Clean deposit on combustion surface.
- Measure valve guide wear and check any hard mark.
Piston
- Clean piston and inspect visually.
- Measure ring groove clearance.
- Visual check on piston ring.
- Measure diameter of piston pin.
Cylinder linear
- Check inner surface.
- Measure bore diameter and make deglazing.
Connecting rod inspection
- Crank pin bolts
- Piston pin bush
- Big end bearing
Crankshaft and main bearing (at first 6000hours)
- Inspection on central main bearing cap and bearing shell.
- Check crank journal at central bearing and all crankpins.
Inspection timing gears
Starting air system
- Overhaul starting air distributor.
- Overhaul starting air valve.
Thermostatic valve element inspection
Measurement tools
- Calibration.
Turbo charger
- Overhaul.
- Measure clearance.
- Replace bearing.(NHP type)
Air cooler
- Clean air and cooling water side.
Fuel injection pump overhaul
- Check deflector and replace if necessary.
- Replace delivery valve spring, ball retainer and ball valve.
Manual of
T/C