IHI NIIGATA MG(L)26HLX, Инструкция по эксплуатации

Страница: 180 / 204

This document is property of NIIGATA POWER SYSTEMS CO., LTD. It must be neither reproduced nor communicated nor published without permission.
SECTION
４
- DISASSEMBLY AND REASSEMBLY
4.8 CAMSHAFT AND TIMING GEAR TRAIN
４－８－０６
Adjusting Timing of Timing Gear Train
WARNING
There is a danger of your hands being pinched by the gear and cam roller of
the engine.
Never insert your hands in the course of turning.
CAUTION
The reference cylinder to be used when adjusting timing will always be the
cylinder that is located to the timing gear.
The camshaft idler gear and camshaft drive gear must be timed with respect to
the crankshaft. Use the following procedure:
- Rotate the engine until cylinder No.6 or No.8 (cylinder at timing gear end of
the engine) is at top dead center. The keyway on the crankshaft gear should
be at the top position, as shown by Figure.
- The timing mark on the camshaft gear and idler gear should be positioned, as
shown by the insert of Figure.