IHI NIIGATA MG(L)26HLX, Инструкция по эксплуатации

Страница: 69 / 204

This document is property of NIIGATA POWER SYSTEMS CO., LTD. It must be neither reproduced nor communicated nor published without permission.
SECTION
２
- OPERATING INSTRUCTION
2.4 STARTING AFTER ENGINEOVERHAUL OR
EXTENDED SHUTDOWN
２－４－０１
WARNING
In cases of fuel leakage from equipment and pipelines of fuel oil line there is a danger
of fire hazard.
Conduct inspection at all times to avoid causing bolts looseness, gasket
deterioration, and equipment and pipeline cracking.
In cases of lubricating oil leakage from equipment and pipelines of lubricating oil line,
there is a danger of fire hazard.
Conduct inspection at all times to avoid causing bolts looseness, gasket deterioration,
and equipment and pipeline cracking.
Any negligence of controlling cooling water, lubricating oil, and fuel oil, and
controlling the clamping in reassembly after overhaul inspection may lead to fault of
the engine and result in physical accidents due to failure of parts.
Unfailing control should be conducted on the basis of instruction manual or
specifications.
CAUTION
Be sure to put on safety goggles in carrying out the following items of work being in
danger of injury to eyes.
・
When handling fuel oil, lubricating oil, cooling water and inhibitor, and anti-freeze
solution
・
In course of washing work
・
In course of fuel injection valve injection test
・
When handling battery electrolyte
・
In course of grinding work
・
In course of intake/exhaust valve grinding Work
There is a danger of injury to your hands during the work inside the engine room and
enclosure.
Be sure to put on gloves for the protection of your hands except for the case of special
work.
2.4 STARTING AFTER ENGINE OVERHAUL OR EXTENDED SHUTDOWN
After major repairs have been made to the engine or after a period of extended
shutdown, all systems should be thoroughly inspected before attempting to start the engine.
Cooling system
・
If pipes or lines were disassembled, check all connections to insure that they are tight.
・
Close all drain openings, and set all valves in the operating positions.
・
Low temperature system - If equipped with a separate motor-driven pump,
start the pump and vent air from the highest point in the system as it is
filling. Recheck all connections for leaks. Check the motor-driven pump for leaks.
・
High temperature system - Same procedure as with low temperature system.
・
If a heater is provided for cold start, it should be turned on to insure
that it is operating properly.