IFM SmartPLC DataLine AC1423, Руководство по эксплуатации устройства

Страница: 88 / 200

SmartPLC DataLine with EtherNet/IP device interface
88
>
Display EtherNet/IP data
41459
To display the EtherNet/IP data:
1 Select the menu page
► > >
►
Select [Data] tab.
2 Display EtherNet/IP data
> Page shows the following information:
Designation Meaning Possible values
[MAC-ID] MAC ID of the EtherNet/IP interface e.g. 00:02:01:01:27:CF
[RPI Zeit] RPI time in milliseconds [ms]
(RPI = Requested Packet Interval)
[Analog. channels/I-slave] Number of analogue channels per input
slave
→ Set the device-specific parameters
(
→ S.
92 )
[Analog.
channels/O-slave] Number of analogue channels per output
slave
→
Set the device-specific parameters
(
→ S.
92 )
[Failsafe state] Behaviour of the AS-i outputs in case of an
interrupted EtherNet/IP connection
→ Set the device-specific parameters
(
→ S.
92 )
[Parameter download] The AS-i slave parameters are transferred
when a EtherNet/IP connection is
established.
Parameter can only be configured via
the projection software!
Parameters are not downloaded, i.e. the AS-i
slaves are activated using the parameters that
are set in the device.
Each time a EtherNet/IP connection is
established, the AS-i slave parameters are
loaded from the EtherNet/IP controller to the
device, activated in the slaves and stored
non-volatilely.
[Change byte order] Byte order in a data word
The set parameter value applies to all
attached tables.
→
Set the device-specific parameters
(
→ S.
92 )
>
Display the module configuration
41436
To display the current module configuration:
1 Select the menu page
► > > .
► Select [Module configuration] tab.
2 Display the module configuration
> The page shows the active configuration of the EtherNet/IP slots (→ Overview: EtherNet/IP modules
(→ S. 161 )).