SmartPLC DataLine with EtherNet/IP device interface
43
►
From the list [IP mode], select either
DHCP
or
BOOTP
.
►
Press [Accept] to save the changes.
>
The device receives the IP parameters from a DHCP or BOOTP server.
The automatic configuration of the interface can take up to 10 seconds.
5 Display the current settings
>
The parameters (→ step 2) show the active IP settings of the EtherNet/IP interface.
>
5.3.6
Quick setup: Set the configuration mode
41774
The device can be configured in two different ways:
Top-down mode:
The device-specific parameters and the module configuration are set via the
projection software of the EtherNet/IP controller.
Independent mode:
The parameters of the EtherNet/IP interface are set via the graphical user
interface of the device.
More information:
→
Configuration mode
(
1 Select the menu page
►
►
Select [EtherNet/IP] tab.
2 Set the configuration mode
►
Set the following parameters as required:
Parameter
Description
Possible values
[Configuration mode]
Active configuration mode of the
device
[
Top-Down
]
The device-specific parameters and the
module configuration are set via the
projection software of the EtherNet/IP
controller.
[
Independent
]
The parameters of the EtherNet/IP interface
are set via the graphical user interface of the
device.
3 Save the changes
►
Press [Accept selection] to save the changes.
>
The selected instance controls the outputs of the AS-i slaves.
