Innovative Circuit Technology Ltd.
37
Watchdog Enabled:
Check this box to enable the network watchdog to cycle
power to an external device on loss of communication.
Primary IP Address:
Enter the primary IP address the unit will ping to
determine the network is functioning.
Secondary IP Address:
Enter the secondary IP address the unit will ping to
determine the network is functioning.
Watchdog Timeout
: Enter the amount of time at which the system will wait
with no ping response from either IP addresses before initiating a power
cycle.
Reset Target:
Select the output to power cycle after the network watchdog
times out. Selecting
LDM Channel Outputs
as the reset target will cause all
load distribution module output channels with the Enable Power Cycling
option enabled to power cycle. Selecting
System DC Output
as the reset
target will cause the main output to power cycle.
Data Logging
Data Logging:
Select
Enabled
to keep a running record of all the key system
parameters and alarms, recorded once per minute for up to the last 30 days.
Click the
Download Log (CSV)
button to store the CSV format log file on your
computer for further analysis.
Log Start Date:
Log start date and time are noted here.
Click on the
NETWORK SETUP
tab to configure the network settings. Click the
Save Settings
button at the bottom of the page to store your changes.
NOTE
:
Saving any changes to the network settings will cause the ICM to restart (i.e.
momentary loss of communications).
Network
MAC Address:
The MAC address assigned to the panel is noted here. It is also
shown on line four of the LCD
NETWORK STATUS
screen.
Enable DHCP
: Check this box (default) if your network uses a DHCP server to
automatically assign IP addresses. To manually assign a static IP address to
the unit, uncheck this box and then enter the following parameters.