IBM ServeRAID, Справочник пользователя

Страница: 77 / 226

Preparing the passive controller
This section covers the following steps:
Step 1. Installing the ServeRAID controller that you will designate as the passive
controller.
Step 2. Configuring the passive controller for failover.
Step 3. Connecting the passive controller to the enclosure; then, starting the
server.
Step 4. Installing the appropriate device driver.
Installing the passive controller
Install the ServeRAID controller that you will designate as the passive controller. For
instructions, see the
IBM Installation Guide that came with the controller.
Configuring the passive controller
Complete the following steps to configure the passive controller for failover:
1. Start the server.
Note: The cables to the drive enclosures must not be attached to the passive
controller when you start the server.
2. Insert the IBM ServeRAID Support CD into the CD-ROM drive. The ServeRAID
Manager program starts.
3. If the ServeRAID Manager program starts the Configuration wizard, a window
similar to the following opens. Click Cancel to exit the Configuration wizard;
then, in the confirmation window, click Yes .
Figure 28. Configuration wizard
Chapter 6. Configuring two ServeRAID controllers in a failover environment
61