IBM ServeRAID, Справочник пользователя

Страница: 33 / 226

4. To remove the battery, gently press the tab up and lift the battery away from
the controller.
5. Remove the two bracket screws. Set them aside.
6. Remove the 3-U bracket.
7. Align the two screw holes in the 2-U bracket with the two screw holes on the
controller. Using the two screws you removed in step 5, secure the bracket to
the controller.
8. Gently snap the battery back into place.
9. Using the screw you removed in step 3 on page 16, secure the battery to the
controller.
10. Return the controller to the static-protective package.
Installing the ServeRAID-5i controller
During the installation, you might need a small, flat-blade screwdriver and the
documentation that comes with your server.
Complete the following steps to install the ServeRAID-5i controller:
1. Review “Safety” on page iii and the Safety Information book provided with your
server.
2. Turn off the server and disconnect all power cords and cables from the server.
Statement 5
CAUTION:
The power control button on the device and the power switch on the power supply do
not turn off the electrical current supplied to the device. The device also might have
more than one power cord. To remove all electrical current from the device, ensure
that all power cords are disconnected from the power source.
Figure 8. Removing the battery from a ServeRAID-5i controller
Chapter 2. Installing and cabling a ServeRAID controller
17