IBM InfoPrint 20, Руководство пользователя

Страница: 106 / 206

Coax Setup Menu
Item Value Description
HLD TMEOUT nn Specifies the hold timeout value. This value tells the printer how
long to wait if the printer is offline for an intervention required
condition to be corrected. After this time elapses, the host is notified
of the error, unless no other coax jobs are pending. If no other coax
jobs are pending, no HLD TMEOUT error notification is sent.
nn can be from 0 to 20 minutes. The default is 1 minute. 0 specifies
to never send a hold time out.
BUSY TMEOUT nnn Specifies the busy timeout value. This specifies the amount of time
to wait (when the printer is connected to multiple ports) for control to
be returned to the coax attachment, before notifying the host. nnn
can be from 0 to 999 minutes. The default is 20 minutes. 0 specifies
to never send a busy timeout.
EDGE-EDGE OFF*
ON Turns edge-to-edge printing on or off.
v
OFF—the printer maintains a border of 4 mm on all four paper
sides.
v
ON—The printer allows printing up to the physical page size.
Notes:
1. To prevent toner from contaminating the printer, IBM
recommends leaving EDGE-EDGE set to OFF for coax printing;
use ON only when necessary.
2. The Coax Setup Menu item EDGE-EDGE applies to SCS data
only. To specify edge-to-edge printing for IPDS data, use the
EDGE-EDGE item on the IPDS Menu.
EAB ENABLE*
DISABLE Enables or disables the extended attribute buffer support.
Note: The EAB menu item also enables or disables the ability to
print IPDS jobs over the coax attachment.
BUFFERSIZE 960
1920*
2560
3440
3564 Specifies the buffer size in bytes.
EARLY COMPL ON*
OFF Turns early print completion on or off for non-IPDS data sent over
the coax attachment. To turn early print completion on or off for
IPDS data, use the EARLY COMPL item on the IPDS Menu.
v
ON—sends an “order complete” as soon as data is received.
v
OFF—waits until the print job is physically complete to send
“order complete.”
Twinax Setup Menu
Use the Twinax Setup Menu to configure the twinax attachment. The following table
describes the settings you can change from the Twinax Setup Menu. An asterisk (*)
next to a value in the table indicates the factory default. The Twinax Setup Menu
appears only if you have the twinax network interface card installed.
Notes:
1. To select a new value, press the Enter key when the value is displayed in the
message display area. An asterisk (*) appears next to the value in the message
display area, indicating that it is now active.
Important! If you change SCS ADDR or IPDS ADDR, you must power off the
printer, wait ten seconds, and then power on the printer for the new value to
take effect.
96
InfoPrint 20: User’s Guide -- Web Version
|
|
|
|
|
|
|