IBM 867413x - Eserver xSeries 330 8674, Руководство по техническому обслуживанию аппаратной части

Страница: 97 / 192

a. Touch the static-protective package containing the new microprocessor to
any
unpainted metal surface on the server/workstation; then, remove the
microprocessor from the package.
b.
Orient the microprocessor over the microprocessor connector as shown in
the illustration. Carefully press the microprocessor into the connector.
Note: To avoid bending the pins on the microprocessor, do not use excessive
force when pressing it into the connector.
Rear of server
Microprocessor
Microprocessor
connector
Microprocessor
orientation indicator
Microprocessor-
release lever
6. Push the microprocessor release lever down to lock the microprocessor into
place.
7. Install the heat sink on the microprocessor:
a. Peel the plastic protective strip off the bottom of the heat sink. Make sure
the square of thermal material is still on the bottom of the heat sink.
b. Align and place the heat sink on top of the microprocessor.
Note: Locate the slot in the channel of the heat sink. Orientate the heat sink
so the slot will be at the rear of the server/workstation.
c.
Align and place the clip over the heat sin; then, snap the clip into place
over the heat sink with the heat sink release lever in the up position.
Note: If you remove the microprocessor later, remember to install the
terminator card in the appropriate microprocessor connector.
d. Press the heat sink release lever down into the locked position once the clip
is in place.
8. Replace the clear shield, then go to “Installing the cover” on page 93.
Note: It is very important to replace the clear shield.
9.
Start the server/workstation and run the Configuration/Setup Utility program.
Installing options
89