IBM 867413x - Eserver xSeries 330 8674, Руководство по техническому обслуживанию аппаратной части

Страница: 137 / 192

Error Code/Symptom FRU/Action
762 (Coprocessor configuration error)
1. Run configuration setup
2. Battery
3.
Processor
962
(Parallel port error)
1. Disconnect external cable on parallel port.
2. Run Configuration/Setup
3. System Board
11XX (System board serial port 1 or 2
error)
1. Disconnect external cable on serial port.
2. Run Configuration/Setup
3. System Board
0001200 (Machine check architecture error)
1. Processor 1
2. Optional Processor 2
3. System Board.
1600
(The Service Processor is not
functioning) Do the following before
replacing a FRU:
1. Do the following before replacing a FRU:
a. Ensure that a jumper is not installed on J28.
b. Remove the ac power to the system, wait 20 seconds; then,
re-connect the ac power. Wait 30 seconds; then, power-on the
system.
2. System Board
1601 (The system is able to communicate
to the Service Processor, but the Service
Processor failed to respond at the start of
POST.)
1. Do the following before replacing a FRU:
a. Remove the ac power to the system, wait 20 seconds; then,
re-connect the ac power. Wait 30 seconds; then, power-on the
system.
b. Flash update the Service Processor.
2. System Board
1762 (Fixed Disk Configuration error)
(IDE drive only)
1.
Fixed Disk Drive
2.
Fixed Disk Cables
3.
Run Configuration/Setup
4. System Board
178X (Fixed Disk error) (IDE drive only)
1. Fixed Disk Cables
2. Run Diagnostics
3. Fixed Disk Drive
4. System Board
1800 (No more hardware interrupt
available for PCI adapter)
1. Run Configuration/Setup
2. Remove Adapter
1801 (no more ROM space available for
PCI adapter)
1.
Run Configuration/Setup
2.
Remove adapter
3.
Disable adapter BIOS on adapter and run Configuration/Setup
1962 (Drive does not contain a valid boot
sector)
1. Verify a bootable operating system is installed.
2. Run Diagnostics
3. Hard Disk Drive
4. SCSI Backplane
5. Cable
6. System Board
Symptom-to-FRU index
129