IBM 867413x - Eserver xSeries 330 8674, Руководство по техническому обслуживанию аппаратной части

Страница: 61 / 192

Working with adapters in the R Pro
Your computer comes with two peripheral component interconnect (PCI) adapter
slots on the system board with riser cards installed in them.
Attention:
1. Your computer also comes with an integrated video controller on the system
board. However, since the video adapter has already been preinstall in a PCI
slot, the computer BIOS automatically disabled the integrated video controller.
This allows the video adapter in the PCI slot to control the video functions for
your monitor.
2. Use only the device drivers supplied on the IntelliStation R Pro Support CD.
The following illustration shows the location of the 33 MHz PCI expansion slots on
the system board.
Note: The illustrations in this document might differ slightly from your hardware.
PCI slot 2
64 bit
33 MHz (J23)
PCI slot 1
64 bit
33 MHz (J10)
Adapter considerations
If you ever need to install an adapter, be sure to review the following:
v
Locate the documentation that comes with the adapter and follow those
instructions in addition to the instructions in this chapter. If you need to change
the switch settings or jumper settings on your adapter, follow the instructions
that come with the adapter.
v
You can install 32-bit or 64-bit full-length or half-length adapters in the
expansion slots. Full-length adapters are installed in slot 1; half-length adapters
are installed in either slot 1 or 2.
v
Your computer supports 5.0 V and universal PCI adapters; it does not support
3.3 V only adapters.
v
Your computer uses a rotational interrupt technique to configure PCI adapters.
Because of this technique, you can install PCI adapters that currently do not
support sharing of PCI interrupts.
Installing options
53