IBM 867413x - Eserver xSeries 330 8674, Руководство по техническому обслуживанию аппаратной части

Страница: 29 / 192

Table 5. NDIS (Windows NT or Windows 2000) driver messages for the Ethernet controller (continued)
Error code (hex) Description
0x02 Explanation: Bad node address (multicast address). Action: Make sure the locally administered
address is valid, if one is specified. The address can not be a multicast address.
0x03 Explanation: Failed self-test. Action: Make sure a cable is attached to the Ethernet connector. If
the problem persists, call for service.
0x0D Explanation: Could not allocate enough memory for transmit queues. Action:
1. From the Windows NT desktop, select Start -> Control Panel -> Networks -> Adapters .
2. Select your IBM Ethernet adapter from the list.
3. Select Properties -> Advanced .
4. Lower the resource values that apply to the transmit queue.
0x0E Explanation: Could not allocate enough memory for receive queue. Action:
1. From the Windows NT desktop, selec t Start -> Control Panel -> Networks -> Adapter s.
2. Select your IBM Ethernet adapter from the list.
3. Select Properties -> Advanced .
4. Lower the resource values that apply to the receive queue.
0x0F Explanation: Could not allocate enough memory for other structures. Action:
1. From the Windows NT desktop, select Start -> Control Panel -> Networks -> Adapters .
2. Select your IBM Ethernet adapter from the list.
3.
Select
Properties -> Advanced
.
4.
Lower the value for the resource named in the message.
0x10 Explanation: Did not find any Ethernet controllers. Action: Using the Configuration/Setup
utility, make sure that Ethernet is enabled.
0x11 Explanation: Multiple Ethernet controllers found, but none matched the required ID. Action:
Using the Configuration/Setup utility, make sure that Ethernet is enabled.
0x13 Explanation: Did not find any Ethernet controllers that matched the required subven/subdev.
Action: Using the Configuration/Setup utility, make sure that Ethernet is enabled.
0x16 Explanation: Single adapter found but multiple instances tried to load. Action: Using the
Configuration/Setup utility, make sure that Ethernet is enabled, and that the slot containing the
IBM Netfinity 10/100 Ethernet Adapter or the IBM 10/100 Etherjet PCI adapter is enabled.
0x17
Explanation:
Slot parameter not specified in the registry.
Action:
Remove the adapter driver and
reinstall it. If the problem persists, call for service.
All other
4-character
hexadecimal
codes Action: Call for service.
Ethernet teaming messages:
Table 6. NDIS (Windows NT or Windows 2000) driver teaming messages for the Ethernet controller
Event ID Type Description
01 Error Explanation: Team Name and physical adapter name are the same. This
is an invalid configuration. Action: Reconfigure the adapter team by
double-clicking the PROSet icon in the control panel.
02 Error Explanation: Unable to allocate required resources. Action: Free some
memory resources and restart.
03
Error
Explanation:
Unable to read required registry parameters.
Action:
Reconfigure the adapter team by double-clicking the PROSet icon in the
control panel.
Diagnostics
21