IBM 867413x - Eserver xSeries 330 8674, Руководство по техническому обслуживанию аппаратной части

Страница: 129 / 192

Beep/Symptom FRU/Action
3-3-3 (No operational memory in
system)
1. Install or reseat the memory modules, then do a 3 boot reset. (See
“Using the Configuration/Setup Utility program” on page 27)
2. DIMMs
3. System Board
Two Short Beeps (Information only,
the configuration has changed)
1.
Run Diagnostics
2.
Run Configuration/Setup
Three Short Beeps
1. DIMM
2. System Board
One Continuous Beep
1. Processor
2. Optional Processor (if installed)
3. System Board
Repeating Short Beeps
1. Keyboard
2.
System Board
One Long and One Short Beep
1. Video adapter (if present)
2. System Board
One Long and Two Short Beeps
1. Video adapter (if present)
2. System Board
Two Long and Two Short Beeps
1. Video adapter
No Beep symptoms
No Beep Symptom FRU/Action
No beep after completing POST
and the system operates
correctly.
1. System Board
No beep and no video (System
Attention LED is OFF)
1. See “Undetermined problems” on page 134
No beep and no video (System
Attention LED is ON)
1. See “Information panel system error LED”
Information panel system error LED
The system error LED is turned on when an error is detected. Push the button
beside the LED display on the system board to illuminate the LEDs. If the system
error LED is on, remove the cover and check the diagnostic panel LEDs. The
following is a complete list of diagnostic panel LEDs followed by the FRU/Action
for correcting the problem. The following chart is valid only when the system error
LED is on.
Note: If a diagnostic panel LED is on and the information LED panel system error
LED is off, there is probably an LED problem. Run LED diagnostics.
Notes:
1. To locate the LEDs on the system board see “System board LEDs” on page 45.
2. Check the System Error Log for additional information before replacing a FRU.
Symptom-to-FRU index
121