IBM 867413x - Eserver xSeries 330 8674, Руководство по техническому обслуживанию аппаратной части

Страница: 115 / 192

packets, the packets from the application with a filter are sent out first. HPQ does
not change network routing, nor does it add any information to the packets.
To assign HPQ, you can specify it using Priority Packet when you create or assign
a filter.
To effectively use HPQ tagging, the adapter cannot be assigned to an adapter team.
Virtual LAN Mode: A virtual LAN (VLAN) is a logical grouping of network
devices put together as a LAN, regardless of their physical grouping or collision
domains. Using VLANs increases network performance and improves network
security.
VLANs offer you the ability to group users and devices together into logical
workgroups. This can simplify network administration when connecting clients to
server/workstations that are geographically dispersed across the building, campus,
or enterprise network.
Normally, VLANs are configured at the switch and any computer can be a member
of one VLAN per installed network adapter. Your Ethernet controller supersedes
this by communicating directly with the switch, allowing multiple VLANs on a
single network adapter (up to 64 VLANs).
To set up VLAN membership, your Ethernet controller must be attached to a
switch that has VLAN capability. You also need to use Windows NT 4.0 or later, or
Novell NetWare 4.1x or later.
Notes:
1. Windows NT versions prior to 4.0 do not support VLANs.
2. VLANs require NT 4.0 with Service Pack 3.0 and the NDIS driver hotfix from
Microsoft.
3. In Windows NT, VLANs cannot be implemented on controllers that have been
configured for teaming options. NetWare can support teaming options and
VLANs on the same adapters.
To join a VLAN from Windows NT 4.0:
1. Create a VLAN on the switch. Use the parameters you assign there to join the
VLAN from the server/workstation. Refer to your switch documentation for
more information.
2.
Double-click the Network icon in the Control Panel window.
3. On the Adapters tab, select the adapter you want to be on the VLAN and select
Properties .
4. In IBMSet, select Join VLAN . Note that VLANs cannot be assigned to adapters
that are already defined to have an adapter teaming option.
5. Enter the VLAN ID and VLAN name. The VLAN ID must match the VLAN ID
of the switch. The ID range is from 1 to 1000. The VLAN name is for
information only and does not need to match the name on the switch.
6. Select Join VLAN . Repeat steps 3 through 5 for each VLAN you want the
server/workstation to join. The VLANs you add are listed on the Adapters tab.
7.
Select
Close
and restart the computer.
Ethernet port connector: The following table shows the pin-number assignments
for the RJ-45 connector. These assignments apply to both 10BASE-T and
Installing options
107