IBM 5500-01E, Руководство по эксплуатации, установке и обслуживанию

Страница: 133 / 192

133
cabling system wall connector.
b. Check for the resistances shown in Figure 70.
Test for Cable Drop between Distribution Panels
Use the following procedure to test the cable drop between the distribution
panels:
1. Disconnect the Y (or jumper cable) that is connected to the cable drop
between panels at the distribution panel that is nearest to the control unit.
2. Go to the distribution panel at the other end of the cable drop and
disconnect any Y (or jumper cable) connected at that end.
3. Install a test connector on the cable drop between panels at the
distribution panel most distant from the control unit.
4. Check for the resistances shown in Figure 71 on page 134
Note: For a continuity test only, use only the first two connections shown in
Figure 71 on page 134.
Figure 70: Last Workstation Failing
Connect Meter Leads As Shown Below
Positive Negative Normal Resistance
Red Orange
0 to 14
W
a
a. If surge suppressors are installed on the line, the normal resistance is 36
to 54
W
.
Green Black 0 to 14
W
Red Green > 5000
W
Green Red > 5000
W
Shield Red > 5000
W
Shield Green > 5000
W