Hypertherm Freedom 38 PPA, Руководство по обслуживанию

Страница: 43 / 218

Freedom 38 PPA Service Manual 809010 43
1 – Troubleshooting
0-50 Retaining cap off On On • Turn OFF ( O ) the system. Verify that the
consumables are installed correctly in the
plasma torch. Turn the system back ON (
I ).
• If the consumables appear to be installed
correctly, the torch may be damaged.
Contact your Hypertherm distributor or
authorized repair facility.
0-51 Start/trigger signal on at power
up
This situation indicates that the
plasma supply is receiving a
start signal. It is sometimes
referred to as a “stuck start.”
On On • If the system is turned on while the torch
trigger is pressed, the plasma cutting
system is disabled. Release the trigger and
recycle the power switch on the back of
the plasma supply (or turn the system OFF
and then back ON again).
0-52 Torch not connected On On • Plug a torch lead into the FastConnect
receptacle on the front of the plasma
supply and recycle the power switch on
the back of the plasma supply.
0-60 AC input voltage error On On • This fault code displays when you turn
OFF ( O ) the main circuit breaker and the
transformer circuit breaker while the
engine and generator are running. Wait
approximately 1 minute to allow the fault to
clear on its own before turning ON (
I ) the
main circuit breaker and the transformer
circuit breaker and starting to cut again.
• If the fault persists, check the
generator/alternator for possible
power-related issues. See
Troubleshoot
power-related issues
(generator/alternator)
on page 38.
0-61 AC input unstable: Shutdown On On • Check the generator/alternator for
possible power-related issues. See
Troubleshoot power-related issues
(generator/alternator)
on page 38.
0-99 System hardware fault –
service required
Indicates a major fault with the
system.
On On • A qualified service technician must service
the plasma cutting system. Contact your
Hypertherm distributor or authorized repair
facility.
Fault
code
Description
Power
LED
Fault
LED
Fault
icon
Solutions