D.11
TE 250R - 310R 2013 I.E. / TE 310R 2013 I.E. USA
TC 250R 2013 - TC 250R 2013 I.E. USA
TXC 250R - 310R 2013 I.E. USA
H11277
B
2
1
1
3
C
A
D
H11278
4mm (0,16 in.)
Workshop Manual Ed. 07-2012
SETTINGS AND ADJUSTMENTS
- Remove the plates (8), lubricate the new plates with engine oil and install
them (always start with a friction plate).
Refit clutch actuator plate, bearing and pressure plate.
Tighten the spring screws gradually in a cross pattern (8 Nm - 0.8 Kgm - 5.8 ft/lb).
When refitting the clutch cover (8 Nm - 0.8 Kgm - 5.8 ft/lb), check gasket for
wear and replace as required.
For additional information on assembly procedures, see Section
"H" Engine assembly.
Hydraulic clutch lever adjustment and fluid level check
Free play (A) must be at least 0,39 in. (10 mm).
The lever position can be adjusted to suit the rider hand size.
To decrease the lever distance from the handgrip, rotate the adjuster (B)
CLOCKWISE.
To increase the lever distance from the handgrip, rotate the adjuster (B) COUN
-
TER CLOCKWISE.
Fluid level is checked as follows:
- Remove screws (1), cover (2) and rubber diaphragm from the control;
- Keep the control cylinder (3) in a horizontal position and make sure that fluid
level has not dropped lower than 4 mm (0.16 in.) below the upper edge (D)
of master cylinder body;
- If needed, top up with the fluid specified in the LUBRICANT CHART included
in Section "A".
Refit any parts you have removed.
Periodically check the connecting hose (see “Scheduled Maintenance Chart”);
if hose (C) is worn or cracked, its replacement is advised.
