H.49
TE 250R - 310R 2013 I.E. / TE 310R 2013 I.E. USA
TC 250R 2013 - TC 250R 2013 I.E. USA
TXC 250R - 310R 2013 I.E. USA
TE-TXC
H11081
H11079
2
3
1
2
4
5
4
TE-TXC
TC
H11080
1
2
2
3
4
4
5
TC
H11082
7
8
8
8
8
ENGINE REASSEMBLY
Workshop Manual Ed. 07-2012
Flywheel cover installation
Install the stator (1) with its mark lined up with the flywheel cover mark and
tighten the retaining screws (2) (use an Allen wrench; for TC use a 4 mm, 4 Nm,
0,4 Kgm, 2.95 ft/lb + Loctite 272; for TE-TXC use a 5 mm, 6 Nm, 0,6 Kgm, 4.43
ft/lb + Loctite 272).
Insert the cable guide (3) into its seat in the cover and tighten the two retaining
screws (4) of the pick-up sensor (5) with its plate (6 Nm, 0.6 Kgm, 4.3 ft/lb +
Loctite 272).
Install the flywheel cover (7) with its gasket and tighten the six screws (8) to 6
Nm, 0.6 Kgm, 4.3 ft/lb.
Make sure the two centring bushings (6) are in place.
