Hudson 1955 Rambler, Техническое и сервисное руководство

Страница: 11 / 292

The slinger is held in place by the crankshaft
sprocket and vibration damper.
CAMSHAFT AND BEARINGS
The camshaft is supported by four steel
shelled, babbitt lined bearings which have
been pressed into the block and line reamed.
The camshaft bearings are step bored being
larger at the front bearing than at the rear
to permit easy removal and installation of the
camshaft. All camshaft bearings are lubri-
cated under pressure through drilled passages
in the cylinder block.
To simplify camshaft removal on the "Hornet"
and "Wasp" Series, remove the radiator core
and grille assemblies and intake exhaust
manifold. Then raise the front of the engine
slightly.
On cars equipped with air conditioning and all
"Rambler" Series, the engine should be
removed for camshaft removal.
The engines should also be removed from the
car if camshaft bearing replacement and/or
line reaming is contemplated.
Camshaft Bearing Oil Clearances
"Hornet" .0015"-.002"
"Wasp" .0005"-.0015"
"Rambler" .001"-.002"
Camshaft Removal
"Hornet" and "Wasp" Series
Remove the radiator, radiator grille, fan
assembly, and intake and exhaust manifolds.
Pull the vibration damper pulley assembly
after removing retaining cap screw. Use
Puller J-676-C for the "Hornet" Series (Fig.
18) and J-5371 "Wasp" Series (Fig. 19).
FIGURE 18—Removing Vibration Damper
Assembly "Hornet" Series
FIGURE 19— Removing Vibration Damper
Assembly "Wasp" Series
Locate engine with timing assembly lined
up as shown in Figure 10.
Remove timing chain cover and cut safety
wire from camshaft sprocket mounting bolts.
Remove camshaft sprocket and chain assembly.
Use Puller 1-471 to remove crankshaft
sprocket (Fig. 20) if a gear change is to be
made.
FIGURE 20— Removing Crankshaft Sprocket
Remove valve side covers and raise valves
and springs sufficiently to install tools
1-1612-3-A tappet holders (Fig. 21). Remove
oil spout on the "Wasp" Series and spout and
chain silencer on the "Hornet" Series.
Remove camshaft thrust plate.
Remove camshaft.
To reinstall the crankshaft sprocket, if
removed, use Driver J-5369 (Fig. 22):
"Rambler" Series
Remove engine from the car. Remove fan
assembly and cylinder head. Remove valve
tappet covers and vibration damper. Remove
valves and valve springs;
8
T E C H N I C A L S E R V I C E M A N U A L