HSD ES779, Перевод оригинальной инструкции

Страница: 120 / 200

6 General post-installation checks
120
HSD S.p.A. © - h0105k01a.fm120718
6.1.4 Electrical connections
The electrospindle earthing (see paragraph 5.8 “Electrical connections” ) must be
connected to the machine earthing.
The thermal alarm must activate a procedure that protects the electrospindle coils
from overheating (see paragraph
7.8.5 “Use and technical characteristics of the
thermal alarm” ).
6.1.5 Programming the inverter
„ Make sure the specifications in paragraph 5.7 “Fluid distributor connections” are complied with.
6.2 Start-up checks
Only start up the electrospindle with the “Tool-holder cone correctly locked” (see
page 140 ).
For HSK versions only: the electrospindle must not be started without the tool-holder
inserted.
„
Tool-holder cone ejection must proceed as specified in section 7.4 “Tool-holder locking and
ejection device” .
„
The control sensors must intervene according to the logic described in paragraph
7.8.3 “Electrospindle conditions and corresponding outputs of the inductive sensors” .
„
The tool change cycle must only take place with the shaft stopped.
„
Check the correct operation of the cooling system.
„
With the tool holder inserted and without performing machining operations, perform the
preheating cycle described in paragraph
7.3 “Warm-up” .