HP Storageworks 8100 - enterprise virtual array, Руководство пользователя

Страница: 312 / 408

SNMP trap configuration parameters
SNMP trap configuration lets you set up to eight trap destinations. Choose from Trap 1 through Trap
8 to configure each trap.
Table 33 describes the parameters for configuring an SNMP trap.
Table 33 SNMP trap configuration parameters
Description Parameter
Enables or disables trap n. If disabled, the trap is not configured.
Trap n enabled
Specifies the IP address to which the SNMP traps are sent. A maximum of eight trap
addresses are supported. The default address for traps is 0.0.0.0.
Trap address*
Port number on which the trap is sent. The default is 162. If the trap destination is not
enabled, this value is 0 (zero). Most SNMP managers and management software
listen on this port for SNMP traps.
Trap port*
Specifies the SNMP version (1 or 2) with which to format traps.
Trap version
* Trap address (other than 0.0.0.0.) and trap port combinations must be unique. For example, if trap 1 and
trap 2 have the same address, they must have different port values. Similarly, if trap 1 and trap 2 have the
same port value, they must have different addresses.
Management Information Base
This section describes the QLogic MIB.
Network port table
The network port table contains a list of network ports that are operational on the router. The entries
in this table include the management port (labeled MGMT), and the GbE ports (labeled GE1 and
GE2).
qsrNwPortTable
SEQUENCE OF QsrNwPortEntry
Syntax
Not accessible Access
Entries in this table include the management port, and the iSCSI ports on
the router.
Description
qsrNwPortEntry
QsrNwPortEntry
Syntax
Not accessible Access
Each entry (row) contains information about a specific network port. Description
A network port entry consists of the following sequence of objects:
Simple Network Management Protocol setup 312