HP Storageworks 8100 - enterprise virtual array, Руководство пользователя

Страница: 256 / 408

Windows initiators may display
Reconnecting
if NIC MTU changes after
connection has logged in
Solution. Log out of the sessions and log in again to re-establish the Connected state.
Communication between HP Command View EVA and MPX200 is down
When communication between HP Command View EV and the MPX200 is down, use the following
options:
• Option 1. Refresh using the iSCSI Controller button.
• Option 2.
• If the Ipv4 management port IP address is set:
1. Discover the controller. This option is exposed through iSCSI controller > Set options >
Discover controller .
2. Enter a valid Ipv4 management IP address under Mgmt Port and click the Save changes
button.
• If only the IPv6 management port IP address is set, enter a valid IPv6 management IP address
under Mgmt Port and click the Save changes button.
HP Command View EVA issues and solutions
Solution Issue
Click the Refresh button on the iSCSI Controller
Properties page.
Check the management port connection.
Check all FC connections.
Discovered iSCSI controller was not found with selec-
ted EVA.
Ensure that the MPX200 is connected to a fabric.
Not a supported configuration. Discovery of the
MPX200 controller with Direct Connect Fibre Channel
attachment mode is not allowed.
Only MPX200 blades that are in the same chassis are
supported for connectivity. Blades in different chassis
are not allowed.
Not a supported configuration. Both MPX200 control-
lers should be in the same chassis/enclosure.
Check FC zoning and connectivity to the EVA.
Not a supported configuration. The MPX200 cannot
be discovered with this EVA.
An EVA FC host exists of which the MPX200 FC port
is a member. Locate the FC host and remove the port. Not a supported configuration. The specified MPX200
controller host port does not exist.
Check all MPX200 FC connections to the EVA.
Virtual disk operation has failed. Ensure that the FC
target connections are online.
Enable the iSCSI controller IP port. Cannot change iSCSI controller IP port attributes.
Check the firmware version and update if necessary.
Command not supported with this version of the iSCSI
controller.
Diagnostics and troubleshooting 256