10. A screen similar to the following is displayed, allowing verification of the settings:
Figure 3-32 The ls Command Screen
11. To return to the MP main menu, enter
ma
.
12. To exit the MP, enter
x
at the MP main menu.
Accessing the Management Processor via a Web Browser
Web browser access is an embedded feature of the MP/SCSI card. The Web browser enables
access to the server through the LAN port on the core I/O card. MP configuration must be done
from an ASCII console connected to the Local RS232 port..
NOTE:
The MP/SCSI card has a separate LAN port from the system LAN port. It requires a
separate LAN drop, IP address, and networking information from that of the port used by HP-UX.
Before starting this procedure, the following information is required:
•
IP address for the MP LAN
•
Subnet mask
•
Gateway address
•
Host name (this is used when messages are logged or printed)
To configure the LAN port for a Web browser, perform the following steps:
1.
Connect to the MP using a serial connection.
2.
Configure the MP LAN. Refer to
“Configuring LAN Information for the MP”
.
3.
Type
CM
to enter the Command Menu.
4.
Type
SA
at the MP:CM> prompt to display and set MP remote access.
Cabling and Power Up
79
Содержание Integrity rx7640
