HP Compaq 6005 Pro MT, Руководство по обслуживанию и ремонту

Страница: 201 / 259

Control panel message Description Recommended action
605-Diskette Drive Type Error Mismatch in drive type. 1. Disconnect any other diskette controller
devices (tape drives).
2. Clear CMOS. (See Appendix B,
Password Security and Resetting
CMOS on page 235
.)
660-Display cache is detected unreliable Integrated graphics controller display cache
is not working properly and will be disabled. Replace system board if minimal graphics
degrading is an issue.
912-Computer Cover Has Been Removed
Since Last System Startup Computer cover was removed since last
system startup. No action required.
917-Front Audio Not Connected Front audio harness has been detached or
unseated from motherboard. Reconnect or replace front audio harness.
921-Front USB 1 Not Connected Front USB harness has been detached or
unseated from motherboard. Reconnect or replace front USB harness.
922-Front USB 1 Not Connected Front USB harness has been detached or
unseated from motherboard. Reconnect or replace front USB harness.
921-Device in PCI Express slot failed to
initialize There is an incompatibility/problem with this
device and the system or PCI Express Link
could not be retrained to an x1. Try rebooting the system. If the error
reoccurs, the device may not work with this
system
1151-Serial Port A Address Conflict Detected Both external and internal serial ports are
assigned to COM1.
1. Remove any serial port expansion
cards.
2. Clear CMOS. (See Appendix B,
Password Security and Resetting
CMOS on page 235
.)
3. Reconfigure card resources and/or run
Computer Setup or Windows utilities.
1152-Serial Port B Address Conflict Detected Both external and internal serial ports are
assigned to COM2.
1. Remove any serial port expansion
cards.
2. Clear CMOS. (See Appendix B,
Password Security and Resetting
CMOS on page 235
.)
3. Reconfigure card resources and/or run
Computer Setup or Windows utilities.
1155-Serial Port Address Conflict Detected Both external and internal serial ports are
assigned to same IRQ. 1. Remove any serial port expansion
cards.
2. Clear CMOS. (See Appendix B,
Password Security and Resetting
CMOS on page 235
.)
3. Reconfigure card resources and/or run
Computer Setup or Windows utilities.
Table C-1 Numeric Codes and Text Messages (continued)
POST Numeric Codes and Text Messages 189