HP BCDVideo BCD108, Руководство пользователя

Страница: 104 / 162

Hardware options installation 104
o
M.2 SSD enablement board installed in slot 3 of the secondary PCI riser
10.
Install the PCI riser cage (on page 24 ).
11.
Install the access panel (on page 22 ).
12.
Install the server into the rack.
13.
Connect each power cord to the server.
14.
Connect each power cord to the power source.
15.
Power up the server (" Powering up the server " on page 21 ).
Dual 8Gb microSD Enterprise Midline USB device
This server supports the installation of the Dual 8Gb microSD Enterprise Midline USB device on the
server internal USB connector.
This USB storage device contains a dual-SD card module that supports up to two SD, SDHC, or SDXC
storage cards providing data redundancy through a mirrored RAID-1 configuration. This USB storage
device connects to an internal USB connector and is configured upon boot.
To locate the internal USB connector, see "System board components (on page 14 )." For more
information, see the Dual 8Gb microSD EM USB storage device documentation on the Hewlett Packard
Enterprise website (
http://www.hpe.com/support/8GBDualMicrosd_ug_en ).
750 W Flex Slot Hot Plug Battery Backup Module
The FSBBU is a self-contained unit with internal lithium-ion batteries that provide DC 12V backup power
for servers when either the main bus utility power fails or the power supply is out of regulation.
You do not have to power down the server before removing or installing an FSBBU.
Flex slot battery backup module configuration load support
The FSBBU module can be daisy chained to only one other FSBBU module. When AC power is lost to
one server, then the loads of both servers will determine if the FSBBU will support the combined load.