horsch LEEB 4 LT, Руководство по эксплуатации

Страница: 115 / 162

9.1 Cleaning
CAUTION
Contamination with crop protection agents.
Strictly use protective outfit when cleaning
the crop protection sprayer! See chapter
"Working with the machine".
¾
Pay particular attention to the brake, air and
hydraulic oil hoses.
¾
Never use gasoline, benzene, petroleum or
mineral oils on brake, air and hydraulic oil
hoses.
¾
After cleaning, check all hydraulic lines for
leaks and loose connections.
¾
Lubricate the trailed sprayer after cleaning,
especially after cleaning with a high pressure/
steam jet cleaner or when using grease dis-
solving cleaning agents.
¾
Pay attention to the statutory regulations
concerning the handling and waste disposal
of cleaning agents.
¾
Check for chafing and signs of other damage.
Remedy any faults immediately!
¾
Prior to working on the electrical system,
disconnect it from the electric current supply.
Cleaning with high pressure cleaner /
steam jet
NOTE
Do not clean new machines with a
steam jet
of a high pressure cleaner.
The paint takes approx. 3 months to cure and
could be damaged before this time.
Strictly observe the following points when clean-
ing with a high pressure cleaner/steam jet:
¾
Do not clean any electrical components.
¾
Do not clean any chromium plated compo-
nents.
¾
Before cleaning the machine cover all open-
ings, which should stay clear of water, steam
or cleaning agents for reasons of safety or
operation.
¾
Do not aim the water jet directly at electrical
or electronic components and bearings.
¾
Do not direct the cleaning jet of the high pres-
sure cleaner/steam jet directly on lubrication
points and bearings, lines and stickers.
¾
Always keep a minimum distance of 300 mm
between cleaning nozzle and machine.
¾
Avoid the use of dirt removing tools on the
high pressure cleaner, if necessary keep a
bigger distance.
¾
Pay attention to the safety regulations when
using high pressure cleaning equipment.
115