horsch LEEB 4 LT, Руководство по эксплуатации

Страница: 114 / 162

¾
Generally perform repair work on the crop
protection sprayer with the pump at standstill.
¾
Disconnect both the machine cable and the
power supply from the on-board computer
before starting service and maintenance work.
This applies in particular for welding work on
the machine. The ground connection must
be as close as possible to the welding point.
¾
Screw connections loosened for the purpose
of care and maintenance work must be
retighten after work is completed.
Appropriate expert knowledge is the pre-
requisite for the performance of tests and
maintenance work. This expert knowledge
cannot be obtained from these operating
instructions!
The following is generally prohibited:
¾
drilling on the undercarriage
¾
enlarging existing boreholes in the vehicle
frame
¾
welding on load bearing parts
Care and maintenance
NOTE
¾
Regular and proper maintenance will keep the
crop protection sprayer for a long time in an
operable state and prevents premature wear.
¾
Regular and proper maintenance is a prereq-
uisite for the acceptance of warranty claims.
¾
Ensure that regular tests and inspections are
always carried out to schedule, as specified
in the operating instructions.
¾
For service and maintenance work park the
machine on level and solid ground, secure it
against rolling away.
¾
Use only original HORSCH-LEEB AS-spare
parts (see also chapter "Spare parts and wear
items as well as auxiliary materials").
¾
Use only spare hoses HORSCH-LEEB AS
and generally use hose clamps made of V2A
for assembly.
¾
When performing cleaning and maintenance
work pay attention to environmental protec-
tion measures.
¾
Strictly comply with the statutory regulations
for the disposal of operating materials, like
e.g. oils and greases. These statutory regula-
tions also apply for parts that had contact with
such operating materials.
¾
When lubricating with high pressure grease
guns do not exceed the lubrication pressure
of 400 bar.
¾
Apply protective measures (e.g. cover or
even disassemble lines at particularly critical
points)
•
when welding, drilling or grinding
•
when working with abrasive cutting wheels
in the vicinity of plastic hoses and electric
lines.
¾
Thoroughly clean the crop protection sprayer
(e.g. with a high pressure cleaner) before
each repair or maintenance, especially all
parts that had contact with spraying mixture.
114