Hog Technologies Stripe Hog SK2000, Руководство по эксплуатации

Страница: 47 / 166

47 47
Stripe Hog Systems
NOTICE:
DAMAGED vACUUM HOSES CAN BE REPAIRED USING DUCT
TAPE AS A TEMPORARY SOLUTION TO EXTEND THE LIFE
OF THE vACUUM HOSE.
Blower And Silencer
The blower is powered by a hydraulic motor. The
hydraulic system is powered by the truck engine
and activated whenever the truck PTO is engaged.
The truck engine must be set the maximum op-
erating RPM to achieve maximum vacuum and
debris recovery.
The blower bearing housing is equipped with two
grease fittings that must be lubricated daily to
achieve maximum life expectancy. Refer to the
Maintenance Matrix in the maintenance section of
this manual and the Root Blower operation manual
for lubrication specifications.
CAUTION
THE BLOWER BEARINGS MUST BE LUBRICATED DAILY WITH
THE GREASE SPECIFIED IN THE MAINTENANCE MATRIX AND
THE BLOWER MANUFACTURER. FAILURE TO LUBRICATE
THE BEARINGS DAILY OR USING GREASE OTHER THAN
THE GREASE SPECIFIED BY HOG TECHNOLOGIES AND
THE BLOWER MANUFACTURER WILL vOID THE WARRANTY.
Blower airflow is expelled through a silencer con -
nected to the outlet side of the blower. A flapper
installed on the silencer exhaust pipe keeps water
and debris from entering the system and damaging
the blower when the unit is shutdown.
The blower components have extremely small toler-
ances and it must be protected from the debris. If
debris ever gets into the blower impellers, use paint/
lacquer thinner or another non-corrosive cleaner to
remove any residue build up inside. It will be neces-
sary to disconnect the hose to the silencer in order
to clean the blower. If large debris gets into the
blower, it can cause severe damage to the blower.
CAUTION
THE BLOWER’S INTERNAL COMPONENTS HAvE EXTREMELY
SMALL TOLERANCES AND MUST BE PROTECTED FROM
THE DEBRIS. ANY FOD (FOREIGN OBJECTS OR DEBRIS)
INCLUDING EXCESSIvE WATER CAN CAUSE SEvERE
DAMAGE TO THE BLOWER.
Vacuum Blower & Silencer
Blower Silencer & Flapper