Hog Technologies Stripe Hog SK2000, Руководство по эксплуатации

Страница: 134 / 166

134
Scheduled Maintenance
Step 7
Install the Swivel Tit Assembly/Gland Nut.
Inspect the O-ring seal inside the gland nut, near the top, and make sure it is not damaged.
Replace the O-ring if it shows any signs of nicks, cuts, deterioration or wear. Apply a light
layer of grease to the O-ring. The grease will help the swivel tit assembly slide over the
O-ring and reduce the possibility for the O-ring to be pushed out of the seat or damaged as
the swivel tit assembly is installed. Figure 13.
Apply anti-seize to the thru-shaft threads. The anti-seize is extremely important and will prevent
the stainless steel threads on the shaft from galling and seizing. If anti-seize is not used and the
threads seize, the thru-shaft will be permanently damaged and the thru-shaft motor will
have to be disassembled and rebuilt!!
Apply anti-seize to the cone and shoulder on the swivel tit and install the brass compression washer.
While holding the thru-shaft with the 3/4” (19 mm) open end wrench, install the swivel tit gland nut
and hand tighten. Then use a 15/16” (24 mm) deep well socket and a torque wrench to tighten swivel
tit gland nut to 50 ft lbs. Figure 14.
Figure 13: O-ring seal seat at the top of the thru-shaft
greased and the threads below the seal coated
with anti-seize.
Figure 14: Swivel tit assembly/gland nut installed on the
thru-shaft and torqued to 50 Ft lbs.
Step 8
Install the Thrust Housing Cap.
Inspect the O-ring seal in the thrust housing cap.
Replace the O-ring if it shows any sign of nicks,
cuts, deterioration or wear. Then apply light layer
of grease to the O-ring. The grease will help the
cap assembly slide into the torque housing and
reduce the possibility for the O-ring to be pushed
out of the seat or damaged as the assembly is
installed. Figure 15.
Figure 15: Inspect and grease the O-ring seal on the
thrust housing cap.
Swivel Tit Assembly
& Gland Nut
O-ring
Seal Seat