Hog Technologies Stripe Hog SK2000, Руководство по эксплуатации

Страница: 29 / 166

29 29
Stripe Hog Systems
Packing lubrication and cooling water is drained
from the UHP pump by a bilge pump drain sys-
tem. The system is completely automatic and
activated whenever the skid main circuit breaker
is activated and panel POWER switch is ON. A fuse
in the outside circuit box protects the bilge pump
circuit from an overload. Refer to Electrical System
section of the manual for additional information
on the bilge system fuse location.
Water drains from the high pressure pump cool-
ing water sump (bilge) by gravity to a sump box
equipped with an automatic float switch that is
connected to the bilge pump. When the water
level in the sump box raises enough to activate
the automatic float switch, the bilge pump is ac -
tivated and pumps the water from the sump box
to the wastewater bladder. When the water level
in the sump box is lowered, the switch will turn
the pump off.
The sump automatic float switch and inside of
the sump box and other internal components are
accessed by removing the sump box lid. It is im-
portant to periodically remove the lid to inspect
the switch and clean out accumulated debris that
can restrict water flow to the pump.
Information and owner’s manuals for the bilge
drain system components are included with this
manual. Refer to this information for additional
operation and service data.
The following bilge pump system compo -
nents should be inspected daily or at the
start of each shift:
• Inspect the cooling water sump (bilge) in the
UHP pump. Clean any debris that may restrict
drainage to the bilge pump system.
• Inspect the drain hoses and sump system for
loose fittings.
• Monitor the operation of the bilge pump sys -
tem at the start of each shift to make sure
the pump and automatic switch are working
properly.
Typical Bilge Pump
Bilge Pump Sump Box
NOTICE:
IT IS IMPORTANT TO INSPECT THE BILGE BOX FREqUENTLY
AND REMOvE DEBRIS, OIL OR OTHER CONTAMINANTS
THAT MAY CAUSE THE AUTOMATIC FLOAT SWITCH TO
MALFUNCTION. USE A WATER BASED GREASE SOLvENT
THEN FLUSH THOROUGHLY WITH CLEAN WATER TO
REMOvE OIL THAT ACCUMULATES IN THE BILGE BOX.