Hog Technologies Stripe Hog SK2000, Руководство по эксплуатации

Страница: 64 / 166

64
Operation
tion. The Pre-Op Checklist provides an itemized
checklist that should be used when performing a
pre-start inspection.
Pre-Start Inspection Items:
1. Check tire condition and air pressure. Make
sure to check the pressure in the tire on the
hydrostatic drive system.
1. Inspect all hoses for chaffing and signs of wear.
2. Check fuel level in the truck and auxiliary fuel
tanks and make sure you have enough for
the shift.
3. Check the truck fluid levels.
4. Check the auxiliary engine and all water blast-
ing system fluid levels.
5. Check all water blasting and vacuum compo-
nents for oil leaks, loose bolts, and damaged
or worn parts.
6. Inspect the Hog Head for loose components
and damage.
7. Inspect the vacuum separator drum and the
condition of the vacuum filter. Replace wipers
or clean filter as required.
8. Inspect clean water tank, hoses and fittings for
leaks and damage. Repair if necessary.
9. Check clean water tank level and fill if neces -
sary.
10. Check that the wastewater bladder is empty.
Drain if necessary.
11. Make sure debris cage door is closed properly.
12. Make sure the correct spray bar and nozzles
required for the removal project are installed.
13. Visually inspect spray bars and nozzles for
damage and excessive wear.
14. Make sure all lubrication points, vacuum
blower motor bearings and Hog Head thru-
shaft bearings are greased with the specified
lubricants.
15. Check all controls, switches and lights for
proper operation.
16. Make sure the Mobile Spare Parts and Tool
Systems are complete and onboard.
17. Conduct a final walk around and visually check
all components. Look for obvious problems
that may have been overlooked.
3.3 Filling The Clean Water Tank
The clean water fill connection on the passenger
side of the tank is a quick connect fitting that ac -
commodates large hoses that are typically con-
nected to a metered source like a fire hydrant to
expedite the filling of the tank. Only use potable
water (clean enough to drink) to increase the
service life of the components in your Ultra-High
Pressure system.
Filling the freshwater tank:
1. Open the man-way on the top of the fresh
water tank and make sure the wastewater
bladder is empty, then close and latch the
man-way.
NOTICE:
WASTEWATER IN THE BLADDER WILL REDUCE CLEAN
WATER TANK CAPACITY. THE WASTEWATER BLADDER
MUST BE EMPTY FOR MAXIMUM CLEAN WATER CAPACITY.
1. If this is the first time using the water source,
flush for several minutes prior to filling the
tank to help ensure that no debris enters the
system.
2. Connect the fill hose to the water source and
flush hose for several seconds.
3. Open the water tank fill valve and connect the
hose to the quick connect fill fitting. Secure the
hose to the fitting with the cam-lock levers.
4. Slowly open the source valve to begin filling
the tank.
Man-Way On Freshwater Tank