Hog Technologies Stripe Hog SK2000, Руководство по эксплуатации

Страница: 96 / 166

96
General Maintenance
4.11 Vacuum Separator Filter
The vacuum separator houses the vacuum filter to
protect the blower from debris during operation.
The pleated, reusable vacuum filter can be easily
removed by opening the separator lid. The filter
should be inspected and cleaned before each shift.
Use the following procedure to drain the can -
ister and remove and clean the vacuum filter:
1. Make sure the separator is lowered and that
the water blasting system is shutdown with
the truck in the service position.
2. Release the clamps and swing the separator
lid open
3. Remove the wing nut that secures the vacuum
filter to the lid and remove the filter.
4. Use a detergent degreaser to cut the oil and
grease, then power wash the filter with pres -
sure not exceeding 2000 psi.
5. Thoroughly inspect the filter for holes and
damage. Replace the filter if its condition is
questionable, if it is damaged or has holes
that could allow debris to get into the blower.
6. Install the cleaned or new filter and secure it
with the wing nut. Hand tighten the wing nut.
Make sure not to over tighten the wing
nut and collapse the filter.
7. Close and latch the separator lid.
Vacuum Filter & Wing Nut
Typical Pleated Vacuum Filter