Seite 79 von 99
14. User Management (B9450 and B9460 only)
User management enables the operator or operators to store 4 sets of preset data. The data stored are;
rim offset, rim width, rim diameter, fine mode, weight placement mode, oz / gram section, mm / inch
selection.
If the user recalls a user with a weight placement mode which is not available for selection in the quick
weight placement selection mode, standard weight placement selection mode is enabled upon user recall.
Select user management by holding down the star and weight keys for 3 seconds while the machine is
idle. A beep is generated.
"SA" is displayed in the left panel and "- -" is displayed in the right panel.
The user can cycle through the four users (A to d) using the plus and minus keys.
The user selects where to save the current settings by pressing return. Pressing return while "- -" is
displayed does not perform a save.
After save, "Rcl" is displayed in the left panel (recall) and "- -" is displayed in the right panel. As before,
the user can specify which user's settings he wishes to recall, or alternatively, by selecting "- -" can
choose not to recall any settings.
A beep is generated, the function exits and the display panels are cleared.
15. User Calibration
The user must balance a wheel in normal mode to less than 5 grams in both planes.
User calibration is selected by holding down the star and fine keys for 5 seconds while the machine is
idle. "Cal 1" is displayed and a beep is generated.
The user performs a wheel spin. After the spin "Cal 2" is displayed. The user mounts the calibration
weight and performs another spin.
After the spin the wheel is braked and there is up to a two second delay. After this delay "Cal dne" is
displayed if calibration was successful. Otherwise an error message is displayed. Possible messages are;
E50
Factory calibration was not completed.
E51 Calibration
failed.
E52
Calibration weight on opposite side to factory calibration.
Any operator wheel spin errors occurring during user calibration or minimisation cause the functions to
exit.
Содержание Snap-on Y2k
