Hofmann Snap-on Y2k, Руководство по обслуживанию

Страница: 69 / 99

Seite 69 von 99
2. Weight Placement Modes
1 N
5
N
N 2 4
3
Figure 2. Weight placement positions 1 to 5. Nominal rim dimensions N1 to N3.
The weight placement modes are described below. These modes are accessed by pressing the "weight"
key. This cycles through the positions available. The order of the list is as follows; Normal, Alu1, Alu2,
Alu3, Alu4, Hwm1, Hwm2, Static.
This key can only be used when the balancer is idle. That is, there is no spin in progress and no other
functions are in use.
Changing the mode causes the leds to change to represent the appropriate weight positions. In the
hidden weight modes, the appropriate HWM led also lights. On cycling the weight mode an audible beep
is generated.
Modes are as follows;
Normal Positions 1 and 5. Rim data required. (Rim data are rim offset,
width and
diameter).
Alu1
Positions 1 and 4. Rim data required.
Alu2 Positions 2 and 4. Rim data required.
Alu3 Positions 1 and 3. Rim data required.
Alu4 Positions 2 and 3. Rim data required.
Hwm1 Positions 2 and 3. Rim diameter and actual weight offsets required. Weights
applied using gauge arm.
Hwm2
Positions 1 and 3. Rim diameter and actual weight offsets required. Stick on
weight applied using gauge arm.
Static Position 3 indicated. Weight can be applied in centre of rim, or
split and applied
at either side (either stick on or clip on).