Seite 41 von 99
11. Check OPTIMA outer scanner
E 364
Affected models
: Models with optima hardware
Service Codes
: All codes available for the model
Right side scanner self test fail or CCD not calibrated or zero mark not detected.
Balancing is not possible since wheel data cannot be scanned.
Problem during power up. Switch power off and on again. Should the problem not go away please call
service.
12. Check OPTIMA inner scanner
E 365
Affected models
: Models with optima hardware
Service Codes
: All codes available for the model
Rear scanner self test fail or CCD not calibrated or zero mark not detected.
Wheel data can be scanned, balancing is possible. Run out measurement of the wheel is not possible.
Problem during power up. Switch power off and on again. Should the problem not go away please call
service.
13. Hardware
tests
C 1 - - - -
Affected models
: All models
Service Codes
: All codes available for the model
There is an error occured during the hardware test. The four hyphens replace the digits 0 to 9 and the letters
A to F which all characterize an error/defect. The following test will be performed:
1. Power supply voltage (235V)
2. 5V line
3. Incrementalencoder (Current of optoelectronic LED)
4. Transducer signal available
5. Auto Stop System (Voltage for relay)
Hardware tests - common errors
14.1
Affected models : All models
Service Codes
: All codes available for the model
C 1 0 F 0 2
C 1 0 F 0 7
C 1 0 F 1 8
A hardware tests couldn't executed successfully.
C10F02: Test returned with an error. No valid test results available.
C10F07: Test function reported an unknown error.
C10F18: Test timed out. No valid test results available
Hardware test - Power supply voltage
14.2
Affected models : Models with motor
Service Codes
: C55 to check line voltage.
C 1 0 8 0 0
C 1 0 8 0 1
C 1 0 8 0 4
If the line voltage is below or above a limit the error code is displayed.
Please refer to chapter 0
Содержание Snap-on Y2k
