Scanreco G2 radio remote control system
39
HMF Technical Service Department
Rev.:
20-13
Programming of ID-code
In order to establish a radio communication between the remote control box and the radio
controller, the two units must be programmed with a unique ID-code.
The ID-code is saved in the remote control box which ensures that it is not possible to transmit
radio signals from another remote control box.
The ID-coding is carried out by connecting the remote control cable between the remote control
box and the radio controller.
After ended ID-coding procedure, the ID-code is saved in the memory of the radio controller.
Procedure for ID coding
1. Take out the battery from the remote control box.
2. Connect the remote control cable between the remote control box and the radio controller.
3. Test the remote control system by operating the crane from the remote control box via the
remote control cable.
4. Push the stop button on the remote control box.
5. Put the tumbler switch on the radio controller in
OFF
position.
6. Turn/pull out the stop button on the remote control box.
7. Put the tumbler switch on the radio controller in
Remote
position, and within 10 seconds
carry out step 8.
8. Push the
ON
button on the remote control box and hold it down for approx. 5 seconds until
you hear a short signal* from the buzzer.
*If the short signal is followed by a long signal, the remote control box turns off and the LED
display of the radio controller shows "
b L
", the ID-coding has not been carried out (see
the chapter: "Reasons for errors when carrying out ID coding" below).
9. Release the
ON
push button and wait a little while.
10. When the ID coding has been carried out correctly, the system acknowledges as follows:
- The buzzer of the remote control box gives a signal.
- The LED display in the radio controller will for approx. 8 seconds show "
Po-Id
”.
- The buzzer gives 5 periodic signals.
- The remote control box turns off.
11. Push the
ON
button and release it again.
12. Wait until the LED display in the radio controller shows "
1 -
".
13. After ID-coding, remove the remote control cable, insert the battery and test the radio remote
control system by operating the crane.
