Scanreco G2 radio remote control system
25
HMF Technical Service Department
Rev.:
20-13
Scanreco "MINI" crane functions,
operation direction A
Scanreco "MINI", position of the levers,
operation direction A
6 linear control levers
4 sections
6 sections
2
3
4
5
6
7
Lever 2
Slew right
Lever 3
Slew right
Boom down
Lever 4
Boom down
Jib up
Lever 5
Jib up
Extension out
Joysticks 2-2-2
2
3
4
5
7
6
Lever 6
Extension out
Fly-Jib, jib up
/ Rotator right
Lever 7
Fly-Jib, extension
out
/ Grab open up
/ Winch down
Joysticks 2-0-2
2
3
4
5
Set-up, CAN control of the crane functions
In the table below is indicated an example of setting up a radio remote control system consisting
of:
- Danfoss PVG 32 control valve.
- PVED electric activations for crane functions.
- PVEO-DI electric activation on the PVSK section for change between crane mode and stabilizer
mode.
- Scanreco G2 radio remote control.
The RCL 5300 software must be version 29_20 or higher.
The example is a standard set-up valid for cranes where the control valve is fitted on the base of
the crane.
Depending on the equipment there may be used other in- and output terminals in the RCL 5300.
Please also see the chapter "Description of Scanreco G2 parameters in the CGW 5355" and
"Setting up of output signals by means of the CGW 5355" as well as the electric diagram IRC,
G2.
Menu item in CGW 5355
Configuration
Description of the function
1.1.1.1.3.17 - Remote control
Press ENT
- Activate the feature
Remote control
.
1.1.1.1.1.17 - Remote control
ENT
- Set up the parameters in the
Remote control
menu
.
1.1.1.1.1.17.1 - Type
SET
- Select
Scanreco V2
by means of the arrow key,
ENT.
1.1.1.1.1.17.2 - RF.Adr
-
- Radio frequency 0.
1.1.1.1.1.17.3 - Ebox SN
-
- Radio controller, serial no. is not indicated.
1.1.1.1.1.17.4 - Recei. SN
-
- Radio receiver, serial no. is not indicated.
1.1.1.1.1.17.5 - Trans. SN
-
- Radio transmitter, serial no. is not indicated.
1.1.1.1.1.17.6 - Lever number
SET
- State number of lever functions, ENT.
