
7 Channel 2.4 GHz Aircraft Computer Radio System
7 Channel 2.4 GHz Aircraft Computer Radio System
Section 1: Introduction
Section 1: Introduction
14
15
1. Function Button:
Used for binding the receiver to the Flash 7 and entering the FAIL-SAFE or Hold
feature.
2. Dual LED Status Indicator:
Indicates the set-up process codes and current status of the receiver.
3. Channel Output and Battery Input Ports:
The ports for battery power input and servos, gyros and
other accessories’ output ports are located at the side end of the Maxima receivers.
4. Low Battery Warning:
If the receiver’s battery levels fall below 3.6V, the RED LED will flash.
5. FAIL-SAFE/Hold Mode Selectable:
Servos and other accessories position can be set with a FAIL-SAFE
point if power to the receiver is lost.
Maxima Series Receiver Features
MAXIMA 6
MAXIMA 9
In Flight Warnings
If the transmitter should start a continuous beeping during flight, land immediately and evaluate the
cause of the warning. There are two warnings that may occur in flight.
Low Transmitter Battery Warning
When the transmitter battery power falls to a critically low level, a warning sound will occur.
Transmitter Warnings cont.
The Maxima series is designed for use with G2 AFHSS radios such as the Aurora 9X and Flash
series. USE ONLY Digital SERVOS with the Maxima receivers. Analog servos cannot be used with
the Maxima series receivers.
arning
Note
Tip
Tip
Tip
Caution
Maxima Series Receiver Antenna Installation
The Maxima receiver series antenna system was created to provide the optimum signal capture
capability. Our two antennas must be installed properly. Refer to the illustration below.
TX
TX
TX
TX
RX
90
˚
Recommended installation
method to optimize
receiver performance
CH1
CH2
CH3
CH4
CH5
CH6
CH7
CH8
BA
T/
9
Electric powered aircraft with Electronic Speed Control
Use this method on electric planes using ESC’s providing power to the receiver and servo functions.
Maxima Series Receiver Connection Diagrams
CH
CH
1
1
CH2
CH2
CH3
CH3
CH4
CH4
CH5
CH5
CH6
CH6
CH7
CH7
CH8
CH8
BA
BA
T/
T/
9
9
SE
RV
O
SE
RV
OS
ER
VO
SE
RV
O
Power Battery
Motor
SE
RV
O
BEC
ESC
Glow, gas or electric powered aircraft using a separate receiver battery supply.
Follow this connection diagram when using a regulated Li-Po, or 4.8 to 6V receiver battery.
SER
VO
SER
VO
SE
RV
O
SER
VO
Receiver
Battery
SE
RV
O
Engine
Содержание Flash7
Страница 1: ......