7 Channel 2.4 GHz Aircraft Computer Radio System
7 Channel 2.4 GHz Aircraft Computer Radio System
Section 4: Common Model Programming Menu
Section 4: Common Model Programming Menu
50
51
PROG.MIX cont.
1. From the model menu, scroll to highlight
“PROG.MIX” and press the jog dial once to
enter the programmable mix menu.
2. Scroll to highlight the mix to be
configured and press the jog
dial to activate the selection.
3. Rotate the jog dial to select ACT (activate),
then press the jog dial to confirm your
selection and activate the sub-menu for
the selected mix.
4. Scroll to select the master/slave
field and press the jog dial to
activate the menu.
5. Scroll to select the master function field (left field) and press
the jog dial to activate the menu.
6. Scroll to select the desired function to be the master function
for the mix (THRO, RUDD, GEAR. etc.) and press the jog dial to
confirm your selection.
7. Scroll to select the slave function field (right field) and press
the jog dial to activate the menu.
8. Scroll to select the desired function to be the slave function
for the mix and press the jog dial to confirm your selection.
Press the back button to return to the programmable mix sub-
menu.
9. Scroll to highlight the “RATE” field and press the jog dial to
activate the menu.
PROG.MIX cont.
10. Scroll to highlight the “L/U” (left/up) field and press the jog
dial to activate the selection.
11. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired left (AILE, RUDD) or up (ELEV)
servo movement for the slave function. Press the jog dial to
confirm your input.
12. Scroll to highlight the “R/D” (right/down) field and press the
jog dial to activate the menu.
13. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired right (AILE, RUDD) or down
(ELEV) servo movement for the slave function. Press the jog
dial to confirm your input.
14. Press the Back button twice to return to the programmable
mix sub-menu.
See the “D/R & EXP” menu on page X for more information about exponential rates.
Warning
Note
Tip
Tip
Tip
Caution
16. Rotate the jog dial to increase or decrease the desired
amount of exponential throw on the slave servo when
operating with the mix. Press the jog dial to confirm your
input.
17. Scroll to highlight the “TRIM” field and press the jog dial to
activate the menu. With this feature enabled, the slave
feature will respond to trim changes as well as control inputs
for the master feature. When disabled, the slave feature
ignores trim changes and reacts only with control inputs to
the master feature.
18. Rotate the jog dial to select “OFF or “ON” and press the jog
dial to confirm your input.
19. Scroll to highlight “S/W” and press the jog dial to activate the
menu.
15. Scroll to highlight the “EXP” field and press the jog dial to
activate the menu.
Example:
Let’s say you want to control your ailerons as fl aps using the one of the slider switches but you
don’t want to have the slider active all the time in case you accidentally bump it. You can assign the slider
to your virtual channel and then P-mix that channel to the aileron servos. Since you have the option to
have the P-mix activated with a switch so that the slider will only be active when the switch is in the on
position. While this is just one example there can be many other uses so if you run into a situation where
you cannot get the results you are looking for through the normal mixing consider using the virtual
channel along with a P-mix.
Содержание Flash7
Страница 1: ......