
7 Channel 2.4 GHz Aircraft Computer Radio System
7 Channel 2.4 GHz Aircraft Computer Radio System
Section 1: Introduction
Section 1: Introduction
10
11
Terms and Icons
Glossary of Terms
AFHSS 2.4GHz Signal: Hitec’s 2.4GHz R/C signal protocol. Adaptive Frequency Hopping Spread Spectrum.
Telemetry: Data signal from the model, transmitted to the transmitter.
Range Check: A ground check of the signal strength between the transmitter and receiver done before
flying.
Link (ID Setting): Link or “binding” a 2.4GHz receiver to its master transmitter.
HPP-22 PC Interface: PC interface accessory for storing model memories and updating firmware.
Icon Identification
MODEL:
The model menu contains the model programming for the active model.
ACRO:
Menu for fixed wing, glow, gas and some electric models.
GLID:
Menu for gliders and some electric models.
HELI:
Menu for rotary wing aircraft.
AILE:
Aileron for fixed wing menus and the “roll” swash input for helis.
ELEV:
Elevator for fixed wing menus and the “pitch” swash input for helis.
RUDD:
Rudder for fixed wing menus and the “yaw”, or tail rotor input for helis.
INH:
Inhibit is used to “turn off” a function.
ACT:
Active, “turns on” a function.
NULL:
“No switch” selected, the function or feature will be “on” all the time.
AUX:
An “open” channel, without a control assigned to it.
J1:
Right gimbal, up and down control.
J2:
Right gimbal, side to side control
J3:
Left gimbal, up and down control.
J4:
Left gimbal side to side control.
T1:
J1 control trim.
T2:
J2 control trim.
T3:
J3 control trim.
T4:
J4 control trim.
RS:
Right slider control.
LS:
Left slider control.
Powering the Flash 7
The Flash 7 includes a 4 x AA battery tray for use with either Alkaline or rechargeable AA size batteries.
The Flash 7 is capable of operating on 4.8 – 8.4 volts DC. This wide range voltage flexibility allows you to
use either 4 NiMh cells or a 2 cell LiPo, LiFe or Li-Ion battery pack.
Selecting the Battery Type
The Flash 7’s default battery type is Alkaline which has a warning threshold of 4.0 volts. If you choose to
use a different type of battery you must select the battery type in the System Management menu.
The preset warning thresholds for each type are
Alkaline 4.0 Volts
NiMh or NiCd 4.3 Volts
LiPo 7.0 Volts
LiFe 6.0 Volts
Power Meter
On the home screen of the Flash 7 you can visually see the voltage reading as well as a bar indicating the
amount of power left in the battery.
Flash 7 Transmitter Controls
Left Slider
Right Slider
Right Gimbal
J1/J2
Left Gimbal
J3/J4
Left Gimbal Trims
Right Gimbal Trims
On/Off Switch
Switch F
Momentary Contact
Switch E
3 Position
Switch A
2 Position
Switch B
2 Position
Button C
Momentary Contact
Switch D
2 Position
Back Button
Jog Dial
Scroll/Enter
Make sure you use a charger suitable for the battery pack you are using. It is recommended that
you remove the battery from the transmitter when charging it.
Warning
Note
Tip
Tip
Tip
Caution
Содержание Flash7
Страница 1: ......