HITEC Flash7, Инструкция по эксплуатации, Страница: 11 / 52

7 Channel 2.4 GHz Aircraft Computer Radio System 7 Channel 2.4 GHz Aircraft Computer Radio System
Section 1: Introduction Section 1: Introduction
18 19
2.4G
Hz 6 Channel
Ai
rc
ra
ft
Re
cei
ver
OPTIMA MINIMA (MAXIMA)
2.4G
Hz 6 Channel
Ai
rc
ra
ft
Re
cei
ver
Optima and Minima Series Receiver Link (ID-Setting or Bind)
Your Hitec AFHSS system uses a communication protocol that links and binds the Hitec 2.4GHz receiver to
your transmitter. Once the receiver and transmitter are “bound”, no other transmitter can interfere.
Turn on the transmitter and select “yes” to the “Ready to Transmit” prompt by
pressing the jog dial.
Press the jog dial and back button simultaneously to enter the System
Menu list. From here scroll to the SPECTRA function and press the jog
dial to enter the Spectra setup menu.
Press the jog dial to
activate the receiver
selection and scroll
to the “Opti&Mini”
receiver.
Back at the receiver
selection screen scroll
to BINDING and press
the jog dial to enter
the binding screen.
Select the type of
receiver you are using,
either Optima or Minima
and push the jog dial to
confirm your selection.
Press the jog dial to save your
setting. When prompted to
change the receiver type select
“Yes” and press the jog dial to
confirm your choice.
Select “Yes” for binding.
Press and hold the link button on the Receiver and turn on the power.
Release the link button. Release the Link button, both RED and
BLUE LEDs will be blinking rapidly to
find the transmitter’s signal.
Optima and Minima Series Receiver Link (ID-Setting or Bind) cont.
When the binding is process is completed, it
automatically goes to the finish screen. (The
BLUE and RED LEDs will be solidly on)
When the LED stops blinking, press the jog
dial to get to the next screen. The blue LED
will glow solid.
Turn the power to the receiver off, then back on. Check for a solid blue LED light. If it appears then press the
jog dial to FINISH the binding process. Make sure all functions are working properly before flying your model.
If any function is not working as described, please go back to step 6 and repeat the
binding again.
If all functions work well press the Finish icon on the screen to finish binding