HITEC Flash7, Инструкция по эксплуатации, Страница: 42 / 52

7 Channel 2.4 GHz Aircraft Computer Radio System
Section 6: Heli Programming Menu
81
7 Channel 2.4 GHz Aircraft Computer Radio System
Section 5: Acro and Glider Programming Menu
80
T. Curve (Acro Only)
b. If you choose a switch:
To disable the throttle curve:
1. Scroll to highlight the “MIX” field in the throttle curve menu
and press the jog dial to activate the menu.
2. Select “INH” (inhibit) and press the jog dial to confirm your
selection.
3. Press the back button to return to the model function menu.
- The current switch position will be displayed in the top right field of the display as “0”, “1”, or “2”. Goes
with above screen shot
- Repeat steps 4-8 to define throttle curve for every switch position.
11. Press the back button to return to the model function menu.
Heli Programming Menu
When the active model is configured as a helicopter model type, the model function menu contains
programming options which are useful for helicopters. This section describes the features and
programming steps for the helicopter model function menu.
The momentary “deadman” switch (Switch-F) is a convenient and commonly-used throttle cut
switch. Throttle cut should be off when the switch is in its neutral position.
Warning
Note
Tip Tip
Tip
Caution
From the model function menu, you can program the following helicopter-specific options:
FLT.COND: Configure specific control settings for different phases of flight.
THRO CUT: Configure a kill switch for glow/gas motors.
T.HOLD:
Set a switch-controlled throttle position.
GYRO: Specify gyro on/off and sensitivity settings.
REVO MIX: Damp unintended yaw movement when not using a heading hold gyro.
SWASH>THRO: Mix throttle with swashplate movements..
T.Curve: Specify non-linear throttle response.
P.Curve:
Configure optimum blade pitch for different throttle settings.
*Swash Ring: Prevent excessive control throw on the swash servos.
FLT.COND: Configure specific control settings for different phases of flight.
Working with Heli Model Function Menu
1. Turn on transmitter. When prompted to transmit, select “NO”.
2. Verify that the active model is a helicopter.
3. To access the model function menu, press and hold the jog
dial.
4. The menu options shown reflect the parameters defined for
the active model in the model type menu (Model Type and
Swash). HELI-specific items are integrated in the menu with
the options that are common to all model types.
F. Cond
The Flash 7 allows you to program up to four flight conditions. This powerful feature lets you define
customized trim values and mix settings for different phases of flight.
The flight conditions for helicopter models are:
1. Normal
2. Idle-1
3. Idle-2
4. Hold