7 Channel 2.4 GHz Aircraft Computer Radio System
7 Channel 2.4 GHz Aircraft Computer Radio System
Section 4: Common Model Programming Menu
Section 4: Common Model Programming Menu
54
55
Timer
a. Selecting “NULL” will cause the timer to be inactive.
b. If you selected a switch, the switch position menu will appear.
- Scroll to highlight the switch position(s) that you will use to
activate the timer.
- Press the jog dial to confirm your selection.
- Scroll to select “ON” and press the jog dial to confirm your
selection. If you toggle the selected switch, the field in the
top right corner of the screen will indicate if the mix is on or
off.
- Press the back button to return to the programmable mix
sub-menu.
c. If you selected “THR”, the throttle position menu will appear.
- Scroll to highlight the top “OFF” field and press the jog dial to
confirm your selection.
- Scroll to select “ON” and press the jog dial to confirm your
selection.
- Scroll to highlight the middle field and press the jog dial to
activate the menu.
- Move the throttle stick to the position where you want the timer to turn on. We suggest a position
just above idle. Note the double line on the screen moves in conjunction with the throttle stick
position.
- Scroll to raise the bar on the screen to the double line. Press
the jog dial to confirm your selection. The timer will run when
the throttle is at or above this setting. It will pause when the
throttle is below this setting. If you cycle the throttle position,
the field in the top right corner of the screen will indicate
when the timer turns on and off.
- Press the back button to return to the timer sub-menu.
14. Scroll to select the desired activation switch for the timer.
Press the jog dial to confirm your selection.
Timer cont.
To reset a timer:
1. From the home screen, scroll to highlight a timer and press
the jog dial once to enter the timer menu.
2. Scroll to highlight “TIME” and press the jog dial to activate the
menu.
3. Press the back button twice to return to the home screen.
To reset the integrated timer:
1. From the home screen, scroll to highlight a timer and press
the jog dial once to enter the timer menu.
2. Scroll to highlight “INTEG-T” and press the jog dial to activate
the menu.
3. Press and hold the jog dial until the timer resets to “00:00:00.
4. Press the back button twice to return to the home screen.
Monitor
1. From the model menu, scroll to highlight “MONITOR” and
press the jog dial once to enter the monitor menu.
2. Manipulate the control inputs (including dual-rate switches)
and observe the bar graphs indicate the movement for each
channel. This screen is useful to verify that each channel is
configured with the intended end points and dual rates.
The Monitor function will display a graphic representation of all seven channels as they are manipulated
with the Flash 7’s controls. There are also channel cycling and neutralization functions.
If you are configuring an electric-powered model, remove the propeller(s) or secure the aircraft
before performing the next steps. The test functions will cause an active Electronic Speed
Control to drive the motor(s) at varying power levels, including full throttle. An unsecured
model can cause substantial bodily injury and/or property damage. Also be mindful of models
with retractable landing gear or similar functions that require special attention.
Warning
Note
Tip
Tip
Tip
Caution
Содержание Flash7
Страница 1: ......